Skip to main content
This section provides instructions on how to set up the infrastructure, build, and flash RTSS firmware.
Prerequisites Before you begin, set up your infrastructure as described in BSP image build with firmware. The Linux build guide describes the common build workflows and flashing instructions.

​
RTSS workflow


The following figure shows the workflow to get started with RTSS on your device.
get_started_with_rtss.png
  1. For instructions about downloading and building RTSS, see Build RTSS firmware.
  2. For instructions about flashing RTSS, see Flash SAIL in the build guide.
To validate RTSS, see Debug RTSS and RTSS test commands. Related documents: For supported hardware information, see Get familiar with the board in the Qualcomm Dragonwing IQ-9075 Evaluation Kit quickstart – Linux documentation.

​
Next steps